Product Description; Window Kit Installation - Concept KV0800 Betriebsanleitung

EN

PRODUCT DESCRIPTION

1 Control panel
2 Upper cover
3 Grille
4 Back cover
5 Front cover
6 Casters
7 Retaining grille (upper)
8 Front retaining grille (upper)
9 Output connection
10 Handle
11 Retaining grille (lower)
12 Front retaining grille (lower)
13 Power cord
14 Exhaust hose assembly
15 Window sealing plate assembly
14
15
FUNCTIONS
• Self-evaporating system - no external water tank required
• The LED display indicates the temperature and operating mode
• On/Off timer function - allows you to choose when the appliance will work
• Compressor protection technology
66
1 2
3
4
5
6
7
8
9
10
11
12
13
KV0800 / KV1000
INSTALLATION
Warning: Please leave the appliance upright for at least 3-4 hours before using it.
This appliance can be easily moved from one room to another.
When moving, keep in mind that it must always be in a vertical position and then placed on a flat surface.
1. Attach the slotted end to the end of the hose by stretching the end and turning it until it is firmly attached (at least
3 full turns) (Fig. 1).
2. Attach the connection at the opposite end of the hose to the outlet on the back of the appliance by plugging it in
and turning it to lock it in place (Fig. 2).
3. Make sure that the unit is in a vertical position and that there are no obstacles on the inlet and outlet grilles (Fig. 3).
Fig. 1

WINDOW KIT INSTALLATION

The window kit (sliding bar and slotted end) can be used for sliding windows and doors. For other types of windows, the
slotted end should be used separately.
1. Partially open the window, and then attach the assembly for window installation to the window.
2. Attach the slotted end of the hose to the opening in the sliding bar.
NOTES
• The window kit is only intended for installation in sliding windows or doors. The window set is not designed or
cannot be used for any other type of window.
• The slotted end adapter can be used with most windows or doors even without a sliding bar.
• When using the air conditioning unit, make sure that the space remaining around the slotted end is as small as
possible, as cooling would otherwise be less efficient.
• The best way to install is to pass through the wall.
• Proper ventilation will expel hot air from the room, while effectively cooling the air in the room.
• Your air conditioning unit can be used without an exhaust hose in dehumidification mode. When using the
dehumidification mode, ensure that an external water tank is used, which will be monitored and emptied regularly
so that it does not overflow. In dehumidification mode, a drain pipe connection can also be installed or an external
water pump can be used for unattended use. The outlet must be well open and must not be blocked, as this would
cause the appliance to overheat. Avoid bending the exhaust hose by more than 30 degrees. See pictures below.
KV0800 / KV1000
EN
Fig. 2 Fig. 3
67