Instruction Manual; Power Supply - Makita CA5000 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Groove cutter blade diameter
Circular saw blade diameter
Max. cutting depth (with groove cutter blade)
Max. cutting depth (with circular saw blade)
No load speed
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Symbols
The followings show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
Groove cutter blade
Circular saw blade
Only for EU countries
Do not dispose of electric equipment
together with household waste material! In
observance of the European Directive, on
Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
Intended use
The tool is specially intended for cutting groove into
composite boards made from aluminum, plastic, mineral
contained plastic, and similar materials.
If the tool is equipped with proper circular saw blade,
the tool can be used for sawing wood and aluminum.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method and
may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may also be
used in a preliminary assessment of exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841:
Work mode: aluminum composite material groove cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
6 ENGLISH
CA5000
118.0 mm
165.0 mm
11.0 mm
36.0 mm
-1
2,200 - 6,400 min
346 mm
4.7 kg
/II
) : 88 dB(A)
pA
) : 99 dB (A)
WA
2
) : 2.5 m/s or less
h
2
2
) : 2.5 m/s or less
h,W
2
2
) : 2.5 m/s or less
h,M
2