Product Features - Würth master H 26-MLE Bedienungsanleitung

Product specifications
Rotary hammer H 26-MLE
Article number 0702 226 X 0702 227 X
Rated power 800 W
Speed control •
Rotation off •
Clockwise/counter- •
clockwise rotation
Replaceable chuck —
Rated speed
- Clockwise rotation 0–900 rpm
- Counter-clockwise 0–900 rpm
rotation
No-load speed 1,300 rpm
Impact rate 0–4 000
rpm
Impact energy per 3.0 J
stroke
Tool holder,SDS-plus •
Spindle collar 50 mm
diameter Ø
Chisel positions 3
Drilling performance
(max.):
- Masonry (core bit) 8 mm
- Stone, concrete 2 mm
- Wood 30 mm
- Steel 13 mm
Weight (without Approx.
accessories) 2. kg
Protection class / II

Product features

1 Keyless replaceable chuck (H 2-MLS)
2 SDS-plus replaceable chuck (H 2-MLS)
3 Tool holder (SDS-plus)
4 Dust protection cap
5 Locking sleeve
6 Replaceable chuck locking ring (H 2-MLS)
7 Rotational direction switch
8 Lock-on button for On/Off switch
9 On/Off switch
10 Release button
11 Mode selector switch
12 Button on the auxiliary handle
13 Depth stop
14 Auxiliary handle
15 Replaceable chuck holder (H 2-MLS)
16 Front sleeve on the keyless replaceable chuck
(H 2-MLS)
12
All manuals and user guides at all-guides.com
17 Retaining ring for the keyless replaceable chuck
18 Extraction clamping screw*
H 26-MLS
19 Extraction depth stop*
20 Extraction telescopic tube*
800 W
21 Extraction wing screw*
•
22 Extraction guide tube*
•
* Not all of the accessories illustrated and de-
•
•
0–900 rpm
The product is intended to be used for hammer drilling
0–900 rpm
in concrete, brick and stone as well as for chiselling
work. It is also suitable for drilling without hammer ac-
1,300 rpm
tion in wood, metal, ceramic and plastic.
0–4 000
The user is liable for damage caused by incorrect use.
rpm
If you have any queries on the product and its use, in
3.0 J
Germany our product and application consultancy
service will be pleased to be of assistance, tel.: 01805-
•
0 5 9 (12 cent/min).
50 mm
3
q When changing the tool, make sure the dust pro-
8 mm
SDS-plus tools
2 mm
30 mm
Due to the nature of the design of SDS-plus tools, the
tool is free to move. This movement will result in radial
13 mm
run-out under no-load; this run-out is automatically cor-
Approx.
rected during drilling. This feature will not impair the
2.9 kg
accuracy of the hole drilled.
/ II
Inserting SDS-plus tools (Figure I)
H 2-MLS: Fit SDS-plus replaceable chuck (see Chang-
ing SDS-plus replaceable chuck).
H 2-MLE / H 2-MLS: Clean and lightly grease the
end of the tool to be inserted prior to insertion. Push
the tool into the tool holder 3 with a twisting action
until the tool locks.
The tool locks automatically. Check locking by pulling
the tool!
Removing SDS-plus tools (Figure II)
Push back (a) the locking sleeve 5 and hold in this
position. Remove tool from the tool holder (b).
(H 2-MLS)
scribed are included as standard.
Correct use
Inserting / changing tool
tection cap is not damaged!