HQ Power VDPDMXC145 Bedienungsanleitung Seite 3

2. Scene Buttons (1 – 8)
Press a button to run or store a scene. The second digit of the LED display shows
scenes 1-8.
3. Faders (1 – 8)
Use the faders to adjust the output level of a DMX channel from 0 to 255. The value
will appear on the LCD display.
4. Page Select
Press this button to switch between page A (the first 8 channels) and page B (the
next 8 channels) of a device.
5. Speed Slider
Adjust the chase speed with this slider (0.1 sec. – 10 min.)
6. Fade Time Slider
Adjust the fade time with this slider (0 – 30 sec.)
7. LED Display
Displays all necessary information
8. Bank Buttons
Press ▲ or ▼ to select a bank. The third and fourth digit on the LED display make
up the bank number (01 – 30).
9. Chase (1 – 6)
Press a button to run or store a chase. The first digit on the LED display is the
chase number (1 – 6).
10. Program
The device is in MANUAL RUN mode when you turn it on. Hold the PROGRAM
button for 2 seconds. The LED flashes and SCENE and CHASE are ready to be
programmed. Hold PROGRAM for 2 seconds again to activate the BLACKOUT
mode. The PROGRAM LED extinguishes and the BLACKOUT indication is lit. Press
the BLACKOUT button to return to the MANUAL RUN mode. The blackout LED
goes out.
11. MIDI / ADD
MIDI : Hold the MIDI button for two seconds when the device is in RUN mode. The
third and fourth digit of the LED display start to flash. Select a MIDI channel
with ▲ or ▼. Press any button other than ▲ or ▼ to end the MIDI channel
setting.
ADD : Push this button to add lines in a program while the device is in the
programming mode.
12. AUTO / DEL
AUTO : Press this button while the device is in the RUN mode. The AUTO
TRIGGER LED is lit, indicating that the AUTO RUN mode has been
activated. Press the AUTO button again to deactivate the auto run mode.
DEL : Push this button to delete a scene or a chase while in the programming
mode.
VDPDMXC145
All manuals and user guides at all-guides.com
3 VELLEMAN