Fancom WEBLINKBOX Installationsanleitung Seite 6

Gndf
When mounting the computer, the following should be observed:
Never mount the network module near water pipes, drainage pipes etc.
Never mount the network module in a place where the weather has direct
influence (not in the sun, or in places where the temperature can rise sharply,
etc.).
Never mount the network module in a humid and/or dusty room and certainly
not in the room where the animals are present.
No condensation may take place in or on the network module.
Use the holes behind the cover screws on the corners of the box to securely
fasten the network module.
Use gland nuts to connect the network module. Use the sealing plates supplied
to seal the gland nuts which are not used. Seal all gland nuts after connection
to prevent the entry of dust, aggressive gases and/or humidity.
To protect against lightning, place an over voltage protection device in the
power supply of the network module.
Take precautions against electrostatic discharge (ESD) when working on the
control computer. Ensure the workplace is clean and dry.
Use the wiring/cables indicated on the connection diagrams and follow all
instructions (see installer manual). Only apply power after the wiring has been
connected correctly. Incorrect connections can cause permanent damage.
Before a new fuse is placed, the cause of the defect should be remedied by an
authorized installer. Only replace a defective fuse by a fuse of the same type
(see connection diagram).
g
3