Adding And Configuring Controllers - Fancom WEBLINKBOX Installationsanleitung

Connecting using portforwarding
The WebLinkBox behaves like a web server. When you have a permanent high speed
Internet connection this server can be made accessible via the IP-address you
received from you local Internet Service Provider. The used technique is called
portforwarding. The settings for portforwarding must be made in the router and/or DSL
modem which are used in your local network. Check the manual of your router how to
set up portforwarding or contact your local IT provider.
Application
Web pages
FarmManager
Ports and protocols available for portforwarding in the WebLinkBox.
This setup is much less secure than using a VPN solution. Always change the default
passwords to avoid unwanted access.
The port for webpages can be changed in the WebLinkBox. Login as installer and go to
the System configuration
browser and press Enter. An extra edit value for the port setting will occur. If the port
number is not default the edit value will always be visible at the
page. Port numbers are valid between 1024 and 65535.
6.

Adding and configuring controllers

In the installer environment you can add and configure connected controllers in the
WebLinkBox. To add and configure the WebLinkBox perform the following steps:
1. Login using the installer password and click Send.
2. Click Control configuration.
Port
80
10000
page. Add /showport to the URL in the address bar of your
Protocol
TCP/IP
UDP
System configuration
Gndf
g
11