To Modify The Cycle; Cycle Transmission; Start Of The Patrol Cycle; Interruption Of The Patrol Cycle - Videotec Dcs2 Bedienungsanleitung

To modify the cycle

Description
E
while 2.Cycle Change is displayed on
If you press
the screen, you have access to the function CYCLE
CHANGE.
BD
The keys allow to select the PRESET position
(from 1 to 14 ) that has to be enabled/disabled.
E
Press in order to enable/disable the displayed
position. In the example the Preset position 01 is disabled.
Repeat the operation for all 14 Preset positions.
C
Press to save and exit.

Cycle transmission

Description
E
while 3.Cycle trans. is displayed on
If you press
the screen, you
TRANSMISSION function.
The Patrol cycle, which has been previously programmed,
is sent to the receiver.

Start of the Patrol cycle

Description
E
while 4.Patrol start is displayed on the
Pressing
screen, the Patrol cycle starts on the receiver.

Interruption of the Patrol cycle

Description
By pressing arrow or

Auxiliary functions (WIPER and WASHER)

w
The key activates/deactivates the control of the washer-pump.
W
The key activates/deactivates the control of the wiper.
have access to
A
keys, patrol function is stopped.
the CYCLE
Page 28
DCS2 display
ENABLED POS.
scan 01: NO
DCS2 display
Transmission ...
DCS29702