Installation - CBE CB510 Bedienungsanleitung

EN

INSTALLATION

Fig.1 - DIMENSIONS (mm):
85
IMPORTANT:
> The installation of this device must be carried out by specialist technicians.
> Caution, do not connect the battery charger
- when a generator set with non stabilised output voltage is employed
- with power mains voltage exceeding the rated value (230V
> Do not carry out any maintenance when the battery charger is connected to the
230V
> In case of battery charger misuse, the guarantee becomes invalid and the manufacturer
declines all responsibility for damages to people and property.
BATTERY CHARGER
- Install the battery charger in an appropriate housing,
dry and ventilated; maximum efficiency can be
obtained w hen the battery charger is installed in a
vertical position (see figure 2), keeping the front at a
minimum istance of 300 mm and the bottom and top d
at a minimum distance of 100 mm from the housing
sides.
- Do not cover air intakes.
- T o guarantee proper air exchange, installation of
two air intakes (one placed on the top and one on
the ottom, see figure 2) ensure a working b
temperature inside the housing not exceeding
50°C.
- M ake sure that the 230V
easily reached.
- T he connection to power supply mains shall be
made in accordance with national installation rules.
- B efore disconnecting the battery charger from
230V power supply, turn the safety switch off.
- I nstallation requires the fixing of 4 pins that can be
easily placed on the 4 sides.
- T he battery charger can be installed together with
CBE 12V and 230V distribution panels, using the
appropriate modular joints.
10
157
110
140
power supply net.
safety switch can be
Fig.2 - VERTICAL INSTALLATION
:
CABLES
- Use cables with appropriate section, minimum
cross section area 4 mm².
- Protect cables from any possible damage.
BATTERY
- Lead-acid batteries shall be positioned in a well
ventilated place.
- U se only 12V (6 cells)
(capacity >40Ah).
WARNING:
> Do not use with "not rechargeable" batteries.
> Exhausted batteries shall be disposed in
accordance with existing environmental
protection regulations.
±10%)
rechargeable lead batteries