Other Convenient Rds Functions And Adjustments; Automatic Selection Of The Station When Using The Number Buttons; Changing The Display Mode While Listening To An Fm Station; Setting The Ta Volume Level - JVC KD-S70R Bedienungsanleitung

Other convenient RDS functions and adjustments

Automatic selection of the station when using the number
buttons
Usually when you press the number button, the preset station is tuned in.
However, when the preset station is an RDS station, something different will happen. If the
signals from that preset station are not sufficient for good reception, this unit, using the AF
data, tunes in another frequency broadcasting the same programme as the original preset
station is broadcasting. In case no other station is tuned in, you can also search all receivable
frequencies for the same programme. (Programme search) To activate programme search,
follow the procedure below.
• Programme search takes a while.
• See also "Changing the general settings" on page 29.
1. Press and hold SEL (select) for more than 2 seconds to call up the general setting mode.
¢ or 4
2. Press
3. Press the + button and set to "ON".
Now programme search is activated.
To cancel programme search, repeat the same procedure and select "OFF" in step 3 by
turning the control dial counterclockwise.
Changing the display mode while listening to an FM
station
You can change the initial indication on the display to station name (PS NAME), station
frequency (FREQ), or clock time (CLOCK) while listening to an FM RDS station.
• See also "Changing the general settings" on page 29.
1. Press and hold SEL (select) for more than 2 seconds to call up the general setting mode.
¢ 4
2. Press or
3. Press + or – to set to the desired indication — PS NAME (station name), FREQ (station
frequency), or CLOCK (clock time).
Note:
By pressing DISP, you can also change the display while listening to an FM RDS station.
Each time you press the button, the following information appears on the display:
PS NAME (Station name)
CLOCK (Clock time)
* Then, the display goes back to the original indication in several seconds.

Setting the TA volume level

You can preset the volume level for TA Standby Reception. When a traffic programme is
received, the volume level automatically changes to the preset level.
• See also "Changing the general settings" on page 29.
1. Press and hold SEL (select) for more than 2 seconds to call up the general setting mode.
¢ 4
2. Press or
3. Press + or – to the desired volume.
to select "P(programme)-SEARCH."
to select "DISPMODE (display mode)."
to select "TA VOL (volume)."
FREQ (Station frequency)
PTY (Programme type)
15