Safety Information; Installation - OHAUS 3000 Serie Bedienungsanleitung

1. SAFETY INFORMATION

Definition of Signal Warnings and Symbols
WARNING
CAUTION
Attention
Note
Warning Symbols
General hazard
Safety Precautions
CAUTION: Read all safety warnings before installing, making connections, or servicing this equipment.
Failure to comply with these warnings could result in personal injury and/or property damage. Retain all
instructions for future reference.

Verify that the local AC power supply voltage is within the input voltage range printed on the equipment's or AC adapter's
ratings label.

Only connect the AC power cord or AC adapter to a compatible grounded socket.

Position the instrument such that the AC power cord or AC adapter can be easily disconnected from the socket.

Position the power cord so that it does not pose a potential obstacle or tripping hazard.

Operate the equipment only under ambient conditions specified in the user instructions.

Do not operate the equipment in hazardous or explosive environments.

Disconnect the equipment from mains power before cleaning or servicing.

Service should only be performed by authorized personnel.
Intended Use
Use the instrument exclusively for weighing as described in the operating instructions. Any other type of use and operation
beyond the limits of technical specifications without written consent from OHAUS, is considered as not intended.
This instrument complies with current industry standards and the recognized safety regulations; however, it can constitute a
hazard in use.
If the instrument is not used according to these operating instructions, the intended protection of the instrument may be
compromised and OHAUS assumes no liability.

2. INSTALLATION

2.1 External Connections
RS232 Interface Cable to T31P
Connect the optional RS232 cable to the RS232 connector.
Pin
1
2
3
4
5
6
7
8
9
AC Power Cord/Adapter Installation
Connect the AC mains/adapter power cord to the instrument's power input connector, and then connect the AC plug to a
suitable electrical outlet.
Attention: Only use an AC adapter specified by OHAUS
For a hazardous situation with medium risk, possibly resulting in injuries or death if not avoided.
For a hazardous situation with low risk, resulting in damage to the device or the property or in loss
of data, or injuries if not avoided.
For important information about the product.
For useful information about the product.
Connection
N/C
TXD
RXD
N/C
GND
N/C
N/C
N/C
N/C
Electrical shock
EN-1