Troubleshooting - AEG CTV 4958 Bedienungsanleitung

Troubleshooting

Before sending the machine to the Customer Services, use the following table to check whether you can rectify the
fault yourself.
Fault Possible cause
The power supply light No power supply
does not light
no power supply/ mains switch
switched off
No image displayed on During operation with a tele-
vision set:
screen
Video cable not correctly
connected
no DVD/CD inserted
DVD/CD not compatible
DVD/CD incorrectly placed in
CD/DVD-tray
CD/DVD is dirty
CD/DVD is damaged
Incorrect settings
The child protection system is
activated
No response when Power supply problem or static
pressing button charging of appliance
No sound During operation with a tele-
vision set:
Audio cable not connected
Volume turned to low
Headphones not correctly
inserted
Amplifier switched off
Incorrect settings
The remote control Wrong direction
Too far away
does not work
Batterie empty
Titles are played in Playlist is used
wrong order
DVD cannot be played DVD has not been finalized
No DVB-T reception The station being received is
too weak for reception via the
telescopic aerial.
No DVB-T reception in your
region.
The station being received is
too weak.
Mosaic similar picture The station being received is
too weak.
Solution
WARNING:
Before searching for the fault, please turn the device off.
Put the mains plug in correctly, if necessary, check the
socket is working with another appliance.
Switch the player on by the mains switch (Fig. 1/3).
WARNING:
Before searching for the fault, please turn the device off.
Check the correct fit of the Video cable. Make sure that
the jacks are tightly in the sockets.
Insert a CD/DVD.
Use only compatible media.
Turn the CD/DVD around.
Clean the CD/DVD around.
Use a different CD/DVD.
Check the settings of your DVD-Player.
Deactivate the child protection.
Switch off the main switch and pull out the mains plug.
Insert the mains plug into the socket and switch the
player on again.
WARNING:
Before searching for the fault, please turn the device off.
Check the correct fit of the Audio cable. Make sure that
the jacks are tightly in the sockets.
Use the VOL+/VOL- buttons (Fig. 2/11, 12) or turn the
volume control +VOL- (Fig. 1/6) to set the volume.
Check that the headphones are correctly positioned.
If you use an amplifier for Audio output: check whether
the amplifier is switched on.
Check the settings of your DVD-Player.
The remote control is not pointed towards the DVD-Player.
Make sure that the remote control is not further than 5 m
away from the player.
Replace the batteries in the remote control.
Delete the playlist.
Use a finalized DVD.
Redirect the antenna or connect your home or room
antenna.
Realign the aerial.
Realign the aerial.
English
67