METREL MD 9930 Benutzerhandbuch Seite 17

MD 9930 Thermal camera
Figure 3: Measure menu
Center: Measure the center point temperature. Highlight and press SELECT to turn
on or off.
Hot: Capture maximum temperature in the image. Highlight and press SELECT to
turn on or off.
Capture: The hotsnap function. See chapter Error! Reference source not found.
for more detailed explanation.
Cold: Capture minimum temperature in the image. Highlight and press SELECT to
turn on or off.
Emiss
Set emissivity and reflected temperature for accurate temperature measurements
and enable alarm temperature. Use UP and DOWN buttons to highlight the menu,
then press SELECT to open.
Emiss – Emissivity: Set Custom by highlighting it, pressing SELECT to open, then
use UP and DOWN to set. The available range is 0.01–1.00 in steps of 0.01. A value
for a material can be chosen in the drop down menu. Navigate to it using UP and
DOWN then press SELECT to use.
Temp.comp. – Temperature compensation: Compensate for any known offset by a
fixed value. Set by selecting, then using UP and DOWN buttons.
17
Settings Menu