Klarstein 10029393 Gebrauchsanweisung Seite 17

EN
ON/OFF key
When you press the key in standby mode, the fan runs at level 1. As soon as you
press the key again, the fan stops. The unit stops, all lights go off and the unit
switches to standby mode.
SPEED button
When the fan is running, you can adjust the speed with the SPEED key. Press
the key several times in succession to adjust the speed. The display shows the
corresponding speed level.
Mode key
Press this key while the fan is running to select the desired mode. Press the key
several times in succession to select the modes in the following order: Natural >
Night Mode > Normal Mode. The corresponding icon will light up.
Wind Direction Button
Press this button while the fan is running to change the wind direction. Press the
key several times in succession to change the wind direction as follows: Swing
right/left > Swing off.
Cooling key
If you press the key during operation, the cooling function is started. The water
pump starts and the cooling LED turns on. If you press the key again, the cooling
function is deactivated. The pump stops and the cooling LED goes out.
Timer/preset key
Press the key several times in succession during operation to set the off timer
in the following sequence: 1 h > 2 h > 3 h > ... > 15 h. Press the key in standby
mode to set the switch-on timer in the following sequence: 1 h > 2 h > 3 h > ... >
15 h. When the preset time is reached, the fan will start automatically. The preset
running time is 2 hours in oscillating mode. After this time the device goes off.
Other functions are not available during this time.
Water leakage protection
If the water tank leaks, the pump stops and the unit emits 3 warning sounds. If
the unit is in cooling mode, the fan is not affected. If the unit is in humidification
mode, the motor will stop if the unit has the corresponding protection function.
The protection is active only in cooling or humidification mode.
17