Maintenance, Cleaning And Repair - Konig & Meyer 19671 Nutzungsinformation

3.) Place the speaker tilt connector with the loudspeaker on the stand
!There is a danger of crushing between the loudspeaker and speaker tilt connector when
the loudspeaker box is mounted!
The operation of the height adjustment on the stand must be taken from the corresponding user
information of the stand.
!Due to the position of the loudspeaker box there is a danger from falling parts!
Disassembly is performed in reverse order.

Maintenance, cleaning and repair

u Maintenance: Regularly check if the screw connections are tight.
u Cleaning: Use a slightly damp cloth to clean the speaker tilt connector.
u
Do not use chlorinated or abrasive cleaning agents. These will cause damage to the surface
u
and varnish.
u Repair: Immediately repair any damage that occurs and stop using the tilt connector.
u
Maintenance work may only be carried out if you have the necessary knowledge. If any parts
u
are missing, contact the manufacturer at www.k-m.de. Here you can find a corresponding
u
spare parts list by entering the article number on the type label. Use this page to reorder
u
missing or damaged components.
Place the speaker tilt connector on the stand and
lock it with the clamping screw. If the speaker tilt
connector cannot be placed on the stand, turn the
clamping screw back until it no longer protrudes
inside the tube.
Place the loudspeaker box on the mounting bolt.
Depending on the weight of the loudspeaker used,
it is advisable to carry out this procedure with another
person. The bolt should be completely immersed in
the speaker and should not tilt. The loudspeaker
position must be adjusted so that the center of
gravity of the loudspeaker is in the center of the
stand.