Contact Information - Konig & Meyer 19671 Nutzungsinformation

Fault and troubleshooting
Fault/cause
Speaker tilt connector cannot
be inserted on stand
Speaker tilt connector does not
fit into loudspeaker holder
Loudspeaker wobbles on the
speaker tilt connector
Unsafe standing of the stand
Storage, disposal
Store the speaker tilt connector in a dry place.
Recycle disassembled components:
u Scrape all components made of metal.
u Recycle or reuse all plastic, paper, and cardboard components.
u Sort all other components according to material composition and dispose of them
u
according to local regulations.

Contact information

KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2
97877 Wertheim
Germany
Phone: 09342/8060
Fax: 09342/806-150
E-Mail: contact@k-m.de
Web: www.k-m.de
19671-000-55 Rev.04 03-80-077-00 2/21
Check/Remedy
● Check the stand tube, it must have a diameter of 35 mm.
● Loosen the clamping screw on the speaker tilt connector,
● it should not protrude into the inside of the support tube.
● The loudspeaker mount must have a diameter of at least
● 35 mm.
● The loudspeaker mount must not be larger than 36 mm
● in diameter.
● Check screw connections for tightness.
● Bringing the loudspeaker center of gravity to the center of
● the stand.
● Align the loudspeaker over one leg of the stand.