Information For Use - Konig & Meyer 19671 Nutzungsinformation

19671 Speaker tilt connector

Information for use

Intended use
The speaker tilt connector is intended to hold a loudspeaker with a mounting diameter of 35 mm.
It is designed for a load capacity of 25 kg. In conjunction with a suitable speaker stand the tilt
adapter is adjustable in a negative or positive angle as well as in height.
Foreseeable misapplication
Placing the loudspeaker off-centre may cause the stand to tip over generating damage to
property or persons. The clamping and adjustment screws must not be opened during use.
General
u The safety instructions of the stand in use must be observed.
u The stand must have a tube diameter of 35 mm.
u The load capacity of the stand must be at least 25 kg.
u The surface should always be clean, dry, level and load-bearing.
u The users must be physically and technically fit.
u There is a risk of crushing between the stand and the speaker during attachment.
u There is a risk of falling parts due to attainable height.
u The usage information's are part of the product and must be kept for its service life or passed
u
on to any subsequent owner or user.
Warranty
No warranty is given for damage caused by:
u Non-observance of the usage information.
u Unsuitable or improper use.
u Incorrect installation or commissioning by the buyer or third parties.
u Natural wear and tear.
u Careless handling.
u Improper modifications or repair work by the buyer and third parties.
u Impact on components of foreign origin.
u Use of non-original spare parts.
Modifications, additions and conversions that may impair safety are prohibited without the manu-
facturer's approval.
Technical data
Material
Load capacity
Dimensions
and adjustment
range
Packing
Weight
Bolt, adjustment plate and support tube: Steel, powder coated black
Screw, washer and nut: Steel, galvanised
Clamping screw: PA and steel, galvanised
25 kg
Bolt: ø 35 x 84 mm
Adjustment plate: 145 x 55 x 6 mm
Support tube: Outer diameter 40 mm, inner diameter 36 x 2 x 110 mm
Height: 205 mm
Inclination: 15°
Adjustment range mounting bolt: 50 mm
295 x 84 x 125 mm
1.2 kg