Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.5 Auto power off
The P 1636 also has an automatic power off function, which serves
to increase the service life of the batteries. The device switches
itself off after approx. 15 minutes if no measurements or settings
have been made with or on the device during this time.
5. Replacing the batteries
If the remaining battery voltage is low, a battery symbol appears on
the display.
To change the batteries, follow the following steps:
1.
Set the switch position of the device to OFF
2.
Unscrew the battery compartment on the back of the
clamp meter and remove the empty batteries
3.
Insert new "AAA 1.5V" batteries into the battery
compartment
4.
Pay attention to the correct polarity of the batteries when
inserting them
5.
Close the battery compartment and screw it back on.
After changing the empty batteries, the battery symbol disappears
from the display when the device is switched on again.
-16-
Werbung
Inhaltsverzeichnis
