Fitting The Vertical Cable Management; Fitting The Table Top - Konig + Neurath PLENUM.K Montageanleitung

5.
Fitting the vertical
cable management
Table width 900/1000/1200:
insert plate (a) and plate (b)
into the slot on the upper part
of the joint (c), fitting the
smaller plate (b) on the inside.
Insert the plates into the slot
of the wedged joint (d).
Table width 1400/1600 (e):
the same procedure as dis-
cribed above.
6.

Fitting the table top

Open the lever of the table top
lock (a).
Position the table top (b) with
clips on the table top lock, pla-
cing the bolts of the clips (c) in
the holes of the table top lock
(d). The top is fixed.
Close the lever of the table top
lock (e).
(a)
(a)
(a)
(c)
(d)
15
(b)
(e)
(b)
(c)
(d)
(e)