Fitting The Legs / Support Legs To The Main Beam; (Depth 900/1000/1200); (Depth 1400/1600) - Konig + Neurath PLENUM.K Montageanleitung

Assembly instructions
Conference system PLENUM.K
These assembly instructions include all the information you need to assem-
ble and reconfigure the PLENUM.K range. Where necessary, each step is
numbered, and the various bolts and Allen key sizes specified.
1.
Fitting the legs /
support legs to the
main beam

(Depth 900/1000/1200)

Loosen the joint connection,
which involves undoing screws
M8x100 in the upper part of
the joint (a) and removing the
lower part of the joint (b) with
the loose hexagon nut M8 from
below. Use a 6 mm Allen key.
The upper and lower parts of
the joint are placed on the con-
tour of the main beam (c) and
then bolted back together.
The lower levelling glide (d) is
used for height adjustment.
2.
Fitting the legs /
support legs and sup-
port parts to the main
beam

(Depth 1400/1600)

Loosen the joint connection as
described on fig.1. The upper
and lower parts of the joint are
placed on the contour of the
beam connector (a) and the
main beams (b), then bolted
back together.
Divided table tops need an addi-
tionally connection plate (c)
between the join connections
underneath the coupling join of
the tops.
Table width 5600 mm:
Needed two additional connec-
tion plates below the middle
table top.
(a)
(b)
(d)
(b)
(a)
13
(c)
(b)
(c)