IGM Professional FKP900-set Gebrauchsanweisung Seite 8

Operating instructions EN
Boring holes into corpus (inserted cup hinge)
Put two stops (pos. 2) into 57 holes (fig. 17). Place FKP on
the workpiece so that central axis of the used cup hinge
spacing on the template is covering with the central axis on
the workpiece and the stops are touching the workpiece
front side. Use the boring bush FKP101 with a dowel bit for
blind holes with 3mm diameter for wood screws or 5mm
diameter for euro screws.
Ensure that the stops are touching the front side of the
board and the hinge axis on the boring template is at the
same place as the hinge axis on the workpiece. Tighten the
boring template to the workpiece by manual tightening
clamps or chucks. Set the boring depth of the boring bush
according to the used wood screws. Put the boring bush
with respective dowel bit into the principal holes range
and bore one hole on the right from the axis and one hole
on the left from the axis (detail fig. 17). Keep the right
revolutions direction - dowel bits are delivered in right-
handed construction. Using the 57 holes, the cup hinge
flange will be shifted by 20 mm, so the distance from the
edge will be 57 mm.
Ensure that the stops are touching the front side of the board and the hinge axis on the boring template is at
the same place as the hinge axis on the workpiece. Tighten the boring template to the workpiece by manual
tightening clamps or chucks. Set the boring depth of the boring bush according to the used wood screws. Put
the boring bush with respective dowel bit progressively into the two holes for the used hinge and bore one hole
on the right from the axis and one hole on the left from the axis (fig. 19). Keep the right revolutions direction -
dowel bits are delivered in right-handed construction.
The holes 3, 4, 5 and 6 are for setting distance between the cap and the door edge; the numbers give
the distance of the 35 mm diameter cap edge from the board edge.
8
Obr. 18.
B
2
A
- illustration - inserted door
Boring holes into the door and cup center
indication
Before boring, the parameters of wood screw spacing,
cup spacing shifting and recommended distance of the
cup from the edge must be determined. For the most
used cup hinges parameters, see PRODUCING HOLES
FOR CUP HINGES.
Put two stops (pos. 2) into one of the holes 3 – 6 (according
to the chosen distance of the cup from the edge) next
to the spacing set corresponding to the used cup hinge
(fig. 18 & 19). Place FKP on the workpiece so that central
axis of the used cup hinge spacing on the template
is covering with the central axis on the workpiece and
the stops are touching the workpiece front side. Use the
boring bush FKP101 with a dowel bit for blind holes with
3mm diameter for wood screws, 5mm diameter for euro
screws or 8mm diameter for instant dowels.
fig. 17.
2
A
www.igmtools.com
2