Producing Holes For Shelf-Supports - IGM Professional FKP900-set Gebrauchsanweisung

Operating instructions EN
WARNING!!!
While boring, press the boring bush to the template to keep the perpendicularity. You can support the boring
bush with the other hand. Always keep the drilling machine perpendicular so that the boring bush is touching
FK with its entire surface. It is better to bore holes on multiple pass. Always follow the safety instructions
for work with the drilling machine!

PRODUCING HOLES FOR SHELF-SUPPORTS

The layout and the lateral piece of the cupboard corpus are
represented in the figure (fig. 8).
The „n" parameter in the figures is for number of holes from the A
A
B
second hole at the 0 stop on (fig. 10 & 12).
- Before boring always check whether the template stops are
perfectly touching the workpiece.
- Always adjust the workpiece from one side on (upper or
under side).
- Check the boring depth before boring.
B
- If the bored hole isn't clean the dowel bit must be grinded.
fig. 8.
Boring holes for shelf supports at front side
Put two stops (pos. 2) into 50 holes and one stop (pos. 2) into 0 hole at the template edge. Place FKP on the
workpiece so that the two stops in 50 holes are touching the workpiece front side and the stop in 0 hole is
touching the workpiece upper side. Thanks to use of the 50 holes, the shelf supports will be placed 50 mm
from the front side. Use the boring bush FKP101 with a dowel bit for blind holes according to the shelf support
diameter (fig. 9).
Ensure that the stops are touching the front and the upper side of the board. Tighten the boring template to
the workpiece by manual tightening clamps or chucks. Set the 8 mm boring depth of the boring bush. Put the
boring bush with respective dowel bit into the principal holes range and bore holes for shelf supports (fig. 10).
Bore rather deep holes on multiple pass, so that the cuttings can be well evacuated. Keep the right revolutions
direction - dowel bits are delivered in right-handed construction. If the distance of the holes from the 0 stop
doesn't suit you remove this stop from the FKP template and shift the template to reach the required
distance. Leave the stops in 50 holes inserted in the template; setting of required distance is more simple thanks
to setting lines in the holes axis.
n=3...
fig. 10.
B
n=2
n=1
B
24
2
d=3/5mm
fig. 9.
2
www.igmtools.com 5