Producing Holes For Cup Hinges - IGM Professional FKP900-set Gebrauchsanweisung

Operating instructions EN
Boring holes for shelf supports at back side
Put two stops (pos. 2) into 30 holes and one stop into 0 hole at
the template edge. Place FKP on the workpiece so that the two
stops in 30 holes are touching the workpiece back side and the
stop in 0 hole is touching the workpiece upper side (fig. 11).
Thanks to use of the 30 holes, the shelf supports will be placed
30 mm from the back side. Use the boring bush FKP101 with a
dowel bit for blind holes with 3mm or 5mm diameter.
n=3...
n=2
n=1
24
Producing of longer joint than the jig
The working procedure is represented in the figure (fig. 13).
The edge stop (pos. 2) removed, the boring jig can
be shifted along the workpiece side. To hold the last
hole and keep the 32 mm spacing, use centering pins
(pos. 3/4/5) delivered with the basis package of boring
template FKP900. The diameter of the delivered centering
pins is 3 mm and 5 mm. The procedure is the same as
when boring with the 0 stop, the template position on the
workpiece is ensured by the centering pin and two stops.
To set the template in a line with the holes already bored,
use a couple of centering pins and place them as far from
each other as possible.

PRODUCING HOLES FOR CUP HINGES

The info figure (fig. 14) is representing the producing
holes for cup hinges.
- Before boring always check whether the template is
perfectly touching the workpiece.
- Always adjust the workpiece from the front side on.
- Check the boring depth before boring.
- If the bored hole isn't clean the dowel bit must be
grinded.
6
fig. 12.
B
2
Ensure that the stops are touching the back and the
upper side of the board. Tighten the boring template to
the workpiece by manual tightening clamps or chucks.
Set the 8 mm boring depth of the boring bush. Put the
boring bush with respective dowel bit into the principal
holes range and bore holes for shelf supports (fig. 12).
Bore rather deep holes on multiple pass, so that the cuttings
can be well evacuated. Keep the right revolutions direction
- dowel bits are delivered in right-handed construction. If
the distance of the holes from the 0 stop doesn't suit you
remove this stop from the FKP template and shift the
template to obtain the required distance. Leave the stops
in 30 holes inserted in the template; setting of required
distance is more simple thanks to setting lines in the
holes axis.
fig. 14.
fig. 11.
2
B
B
3/4/5
fig. 13.
A
3-6mm
D=35mm
www.igmtools.com
B