Producing Of Dowel Holes Into Surface; Boring Dowel Holes Into Surface - IGM Professional FKP900-set Gebrauchsanweisung

Operating instructions EN

PRODUCING OF DOWEL HOLES INTO SURFACE

Trace a line going across the workpiece and cutting the centre of the vertical element (fig. 4) on the surface of
the workpiece you want to have bored the holes on. Insert the setting pointed stop (pos. 2) into the 0 hole at
the edge of the template. Place the FKP on the workpiece so that the edge stop is touching the front side of the
workpiece and the axis of the template holes is on the line traced on the workpiece (fig. 5).
2
A
B
B
fig. 5.
fig. 4.
Ensure that the setting pointed stop is touching the front side of
the board and the central axis of the template holes is covering
with the workpiece line. Tighten the FKP by tightening clamps.
Set the boring depth 15 mm on the boring bush, the workpiece
thickness being 18 mm. Put the boring bush with respective
dowel bit into the holes and bore dowel holes (fig. 6). Bore rather
B
deep holes on multiple pass, so that the cuttings can be well
evacuated. Keep the right revolutions direction - dowel bits
are delivered in right-handed construction.
BORING CONFIRMATE HOLES INTO SURFACE
2
The procedure and the layout of the elements are the same as at
the producing of dowel joint into surface. Use a 7 mm diameter
B
dowel bit for through holes ad the boring bush FKP102. Set the
boring depth so that the dowel bit can surely bore through the
fig. 6.
workpiece thickness. Keep the right revolutions direction - dowel
bits are delivered in right-handed construction.
To produce dowel or confirmate joints into side, the use of boring jig for side dowelling FKP400 or
FKP656 is recommended.
3/4/5
Producing of longer joint than the jig
The working procedure is represented in the figure (fig. 7).
The edge stop (pos. 2) removed, the boring jig can be
shifted along the workpiece side. To hold the last hole
and keep the 32 mm spacing, use centering pins (pos.
3/4/5). The boring template is delivered with centering
pins for 8 mm, 5 mm and 3 mm dowel diameter. The
procedure is the same as when boring with the edge stop,
the edge stop is replaced by the centering pin. To set
fig. 7.
the template in a line with the holes already bored, use a
couple of centering pins and place them as far from each
other as possible.
www.igmtools.com
4