Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions EN
CONTENTS
USE OF TEMPLATE FKP900
The template FKP 900 is designed to produce furniture elements joints in surface with dowels for board
thickness between 18 and 30 mm or with confirmate screws of 40-50-60 mm for board thickness of 18 - 30
mm, to prebore holes D3mm and D5mm for shelf supports and to produce of holes for woodscrews and hinge
flange and cap. For these operations, the boring bush FKP101 and any cordless or percussion drill are required.
The ingenious boring bush conception enables the use of one boring bush with a wide range of dowel bits with
various boring diameters. The whole system is based on the template made of laminated pertinax, setting stops
set and a boring bush in which a dowel bit with HM cutting edge is clamped. Thanks to the clever construction,
maximal precision of boring template and boring bush you can obtain a unique quality of your products.
Basic accessories FKP 900-set:
- Boring template FKP 900
1 pc Template from laminated pertinax
4 pc Steel pointed setting stops D6/D9mm
2 pc Steel centering pins D3
2 pc Steel centering pins D5
2 pc Steel centering pins D8
- Bring bush FKP101
- Dowell bit D5x30 mm C306-05011
Accessories required for work with the template:
- ELECTRIC OR ACCU DRILLING MACHINE
- BORING BUSH FKP 101
Dowel bits with HM cutting edge and tightening shank S=8 mm
D 8x30 mm dowel bit HM__C306-08011__for FKP101 (blind holes)
D 3x30 mm dowel bit HM __C306-03021__for FKP101 (blind holes)
D 5x30 mm dowel bit HM __C306-05011__for FKP101 (blind holes)
D 7x30 mm dowel bit HM __C367-07001__for FKP101 (through holes for confirmate screws)
D35x90 S10 mm manual hinge boring bit HM__C512-35011 __ (boring cup hole for hinge)
Description of template FKP900
The whole system is composed of a boring template (pos. 1) with precise 18 mm diameter and 32 mm spacing
holes, of holes for cup hinges, holes for stops, of pointed stops (pos. 2) for position marking and of centering
pins (pos. 3-5) for holding position when shifting template. The holes for stops are indicated with numbers for
important dimension relative to the particular stop. The boring template is tightened to the workpiece with
manual clamps or chucks.
2
3
2
4
4x
2x
PAGE
5
6
2x
2x
www.igmtools.com
2
3
4
4
5
6
9
10
1
7
Werbung
Kapitel
Inhaltsverzeichnis
