IGM Professional FKP900-set Gebrauchsanweisung Seite 7

Cup hinges spacing
Screws at the cup hinge flange: spacing 32mm / from the edge 37mm
45
10
45/10 mm
T
ekno
Elements preparation before boring – cup
hinge axis indication
Indicate the hinge axis and the distance from upper and
under side on the inner side of the corpus lateral piece. If
possible, the 120 mm distance form the element edge is
recommended. Put the door to the lateral piece so that
there are the same laps from the edges on both sides.
Copy the cup hinges axis on the inner side of the
door. Indicate axis of cup hinges ca. 120 mm from the
lateral piece and the door edge using a set square. The
precision of the cup hinges indication will influence the
altitude of the door (fig. 15).
- illustration - overlapping door
2
fig. 16.
www.igmtools.com
45/9,5 mm
B , I
lum nTerex
A
A
Operating instructions EN
52/5,5 mm
H
eTIcH
fig. 15.
Boring holes into corpus (overlapping cup
hinge)
Put two stops (pos. 2) into any holes in the range
for cup centers indication (fig. 16). Place FKP on the
workpiece so that central axis of the used cup hinge
spacing on the template is covering with the central
axis on the workpiece and the stops are touching the
workpiece front side. Use the boring bush FKP101
with a dowel bit for blind holes with 3mm diameter
for wood screws or 5mm diameter for euro screws.
Ensure that the stops are touching the front side of
the board and the hinge axis on the boring template
is at the same place as the hinge axis on the workpiece.
Tighten the boring template to the workpiece by
manual tightening clamps or chucks. Set the boring
depth of the boring bush according to the used wood
screws. Put the boring bush with respective dowel bit
into the principal holes range and bore one hole on
the right from the axis and one hole on the left from
the axis (detail fig. 16). Keep the right revolutions
direction - dowel bits are delivered in right-handed
construction.
48/6 mm
S , F , D
alIce vg anco
3-6mm
D=35mm
A
B
7