Herunterladen Diese Seite drucken

Caliber CA4050 Bedienungsanleitung Seite 6

Vorschau ausblenden Andere Handbücher für CA4050:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 10
F E a t u R E s
• Bridgeable outputs.
• 'Tri-mode' output capability, simultaneous stereo & bridged mono set up is possible.
• Pulse Width Modulated (PWM) MOSFET Power Supply.
• Variable input sensitivity: RCA input 0.5V to 2V.
• Thermal-, Overload- and Shortcircuit protection.
• Excellent muting circuitry assures no turn on/off 'pops'.
• Built-in High Pass / Full Range / Low Pass Filter Switch. 50Hz - 250Hz
• Chrome plated power connectors for optimal power distribution.
• European design and engineering.
• Chrome plated speaker connectors for optimal signal output.
M O u n t i n g
The amplifier has to have at least 5 cm (2") ventilation space at all sides, to allow the heat to rise
2
away from the amplifier. Be sure that the power and signal cables can enter and leave the ampli-
fier in a straight line, to avoid the risk of malfunction. Always place the power- and signalcables at
opposite sides of the vehicle to reduce any noises.
The amplifier should be protected from exposure to moisture and direct sunlight.
Mark the mounting surface using the amplifier as a template, then drill 2.5 mm (1/8") diameter
holes at the marked locations and mount the amplifier using the supplied self-tapping screws.
i n s t a l l a t i O n
Remember to always disconnect battery ground before working on a vehicle's electrical system!
Always place a fuse or circuit breaker no more than 30 cm (12") from the battery, no greater
than the fuse(s) of your amplifier for optimal protection.
g E t t i n g y O u R P O w E R s t a R t E D
First, the +12V terminal is connected directly to the battery of your car. Use a cable of at
least 10 mm 2 , and make sure that the connectors are of the same value.
- Don't forget the extra "Vehicle protection" fuse.
- The 12V + terminal should NOT be connected to the car fuse box.
Second, the ground terminal (GND) must be fastened securely to the chassis of the vehicle with
the same mm 2 cable as the positive cable (the same amount of power has to run through it).
Ensure that all paint, undercoating or any other insulation is removed from the area where you
want to make your ground connection to.
Third, the last cable to connect is your remote turn-on (REM). Many radio-cassette and
CD-players have an output terminal for connection of the REM of an amplifier. If you don't have
such an output, a separate switch must be installed to control your amplifiers on/off function.

Werbung

loading