Calibration Of The Water Temperature Measurement; Bluetooth Communication; Settings Reset - ULS PAPI004215-INTER5 Gebrauchsanweisung

2.6.5. Calibration of the water temperature measurement

If the temperature sensor is disabled, the menu below does not appear.
Menu
Positive value,
from - to + 5°C compared to the value displayed, in increments of 0.5°C

2.6.6. Bluetooth communication

Menu Setting
Mode
Pairing*
Reset*
During a (non-automatic) update of the electronics unit software carried out via Bluetooth:
- The 2 LEDs (red and green) flash alternately.
- The message

2.6.7. Settings reset

Menu
Possible settings
Function
Activation/deactivation
Bluetooth communication
Detection of connectible
devices near the electronics
unit (within 60 seconds)
Networking
electronics
connected devices
Deletion of
connecting
unit to the connected devices
* These settings do not appear if the mode is set to OFF.
is displayed.
Resetting the settings cancels all the settings carried out (factory configuration).
of
of the
unit and
the pairing
the electronics
Important warning
I
Current measurement
Possible settings
ON (to activate)
OFF (to disable)
-
Default setting
Default setting
ON
8