HP DesignJet T940 Einführende Informationen Seite 5

Ventilation measures for your location, whether office, copy room, or printer
room, should meet local environmental health and safety (EHS) guidelines and
regulations.
Electrical shock hazard
The internal circuits of the built-in power supplies and power inlet
WARNING!
operate at hazardous voltages capable of causing death or serious personal
injury.
Unplug the printer's power cord before servicing the printer.
The printer requires a building installation circuit breaker, which must meet the
requirements of the printer and should be in accordance with the Electrical Code
requirements of the local jurisdiction of the country in which the equipment is
installed.
To avoid the risk of electric shock:
The printer should be connected to earthed mains outlets only.
●
Avoid overloading the printer's electrical outlet with multiple devices.
●
Do not remove or open any closed system covers or plugs.
●
Do not insert objects through slots in the printer.
●
Take care not to trip over the cables when walking behind the printer.
●
Insert the power cord securely and completely into the wall socket and
●
printer inlet.
Never handle the power cord with wet hands.
●
Fire hazard
To avoid the risk of fire, take the following precautions:
The customer is responsible for meeting the printer's requirements and the
●
Electrical Code requirements according to the local jurisdiction of the
country where the printer is installed. Use the power supply voltage
specified on the nameplate.
Use only the power cord supplied by HP with the printer. Do not use a
●
damaged power cord. Do not use the power cord with other products.
Do not insert objects through slots in the printer.
●
Take care not to spill liquid on the printer. After cleaning, make sure all
●
components are dry before using the printer again.
ENWW
Safety precautions
3