Zeegma Zonder Robo Next Bedienungsanleitung Seite 9

Water tank (see fig. 5):
8.
Water inlet hole
9.
Water tank
Remote control (see fig. 6):
12.
Return to docking station
13.
Go forward
14.
Turn right
15.
Suction power adjustment
16.
Edge vacuuming
17.
On/off
3. How to assemble (see fig. 7):
•
Press the water tank release key, and then remove the tank.
•
Fix side brushes, left and right (L / R).
•
Before you use the device, remove the protective strip.
4. How to use:
How to store and charge:
•
Place the docking station by the wall, on a flat surface. Leave some free space around
the station, that is 0,5m to the left and right, and 1,5m before the station (see fig. 8).
•
Supply power to the docking station and plug in (see fig. 8).
•
Activate the main switch of the product. „I" stands for ON, and „O" means OFF (see fig. 9).
Two ways of charging (see fig. 10):
1.
Place the product on the docking station.
2.
For charging, use the power supply (when charging, the signaling light flashes, when
charging is over, it turns green
•
When the battery goes flat during cleaning, the product automatically switches into
charging mode and goes to the docking station to initiate charging.
•
Activate the charging mode with the return-to-docking-station key on the remote
control or via the application.
Charging notes:
1.
The docking station must not be used in a direct sunlight.
2.
Before you start using the product, remember to fully charge it. Charging takes 4 hours.
10.
Mop
11.
Tank release key
18.
Pause/Start
19.
Turn left
20.
Reverse key
21.
Suction power adjustment
22.
Spot vacuuming
EN