Intended Use; Queries And Technical Problems - Miele professional A 600 Gebrauchsanweisung

The A 600 module can be used in the A 502 injector unit. The injector
unit is supplied with its own operating instructions.
5 mm and 8 mm shafted instruments for da Vinci® S and Si system
robots that have two rinse connections on the upper end of the
casing can be reprocessed in the A 600 module.
Special instruments cannot be reprocessed in the A 600 module
holders.
Additional holders are required for reprocessing these. See chart.
Miele have tested the reprocessing of instruments with the
ROBOTVARIO X·tra programme and thermosept® X·tra cleaning
agent (manufactured by Schülke & Mayr) and recommend the use of
this procedure.
This programme does not come as standard for PG 8527 and PG
8528 washer-disinfectors and must be added to the Profitronic unit
retrospectively by Miele.
Suitable instruments
EndoWrist® 8 mm
EndoWrist® 5 mm
Single-Site® without rinse connection on the
shaft
Single-Site® with rinse connection on the
shaft
PK™ Dissecting forceps
da Vinci® S/Si stapler
Medical devices for reprocessing are referred to as the wash load if
they are not more closely defined.

Queries and technical problems

If you have any queries or technical problems that you would like to
discuss please contact Miele. Contact details can be found at the
back of the Operating Instructions for your washer-disinfector or go
to www.miele-professional.com.
en - Intended use
A 600
●
●
●
+ A 806
+ A 807
+ A 805
39