Connecting The Dispensing Hoses - Miele professional DOS K 85 Montageanweisung

en - Connection
Connecting the
dispensing hoses
40
The DOS module is tested at the factory for functionality.
Any residues of the harmless test medium are a result of this testing
and not evidence of previous use.
Pull the safety cap off the end of the hose and remove the protecti‐

ve foil from the siphon.
Connect the hose to the dispenser connection on the washer-disin‐

fector.
The flowmeter has to be fitted between the DOS module and the
dispenser connection.
Connect the module to the electricity supply.

Connections for the electricity supply and the dispensing hose are
located at the back of the washer-disinfector.
(These are described in detail in the Operating instructions for your
washer-disinfector).
Fill or replace the container, fit the siphon and secure the lid.

Feed the siphon into the container until it reaches the bottom.

Instructions for venting the dispensing system and setting the dos‐
age are given in the Operating instructions for your washer-disin‐
fector.