Program List; Cycle Counter - Panasonic NE-1880 Bedienungsanleitung

X To Select Length of Tone "short beeps for 60 seconds":
PAD
Follow steps 1 to 3 on page 23.
4
Within three seconds after pressing Program Entry Switch at
step 3, press Buzzer Switch.
"PROG" will start to blink and 2nd Stage Heating Indicator "2" (the
BUZZ
length of beep tone "short beeps for 60 seconds") will be indicated.
5
Press Program Entry Switch again.
"PROG" will stop blinking. This means that you have completed
programming.
Three seconds later, the display window will go blank when the
PROG
door is closed.
F. PROGRAM LIST
PAD
1
Open the door and leave it open.
The oven lamp will turn on and "0" will appear.
2
While pressing Stop/Reset pad, press Start pad.
All currently programmed information (the program set into each
Memory pad (A/B sides), Beep Tone, and Program Lock
information) will continuously appear.
+
G. CYCLE COUNTER
X To Read Total Cumulative Times That The Oven Has Been Used:
PAD
1
Open the door and leave it open.
The oven lamp will turn on and "0" will appear.
2
Close the door.
Carry out Step 3 within 60 seconds of closing the door, or the
display will go blank.
3
While pressing Buzzer Switch, press Program Entry Switch.
+
The display shows the total cumulative number of times the oven
has been used.
BUZZ PROG
How to Operate NE-1880
INSTRUCTION
INSTRUCTION
INSTRUCTION
- 24 -
DIGITAL DISPLAY WINDOW
PROG
1
PROG
2
PROG
2
DIGITAL DISPLAY WINDOW
PROG
A
1
PROG
B
1
2
DIGITAL DISPLAY WINDOW