Clamping Forces - Sartorius Stedim Sartocon Bedienungsanleitung

5.2 Clamping Forces

Sartocon ® Slice 200 and Sartocon
Cassette type Part number
Slice 200 and 308144...
Slice Hydrosart ® UF 305144...
Slice 200 and 308146...
Slice PESU UF 305146...
Slice 200 and 308186...
Slice Hydrosart ® MF 305186...
Slice 200 and 308154...
Slice PESU MF 305154...
Sartocon ® 2 plus Holding Device, Manual closure
Cassette type Part number
Sartocon Cassettes 302146...
®
302154...
Hydrosart MF | UF 302144...
®
Sartocon ® Cassettes 302186...
Sartoflow 10 | Sartoflow
® ®
Cassette type Part number
Sartocon Cassettes 302146...
®
302154...
Hydrosart MF | UF 302144...
®
Sartocon ® Cassettes 302186...
* List of sterilizable cassettes is available in "Technical Data", section 6.
** After every tenth time of use, the PEEK washers should be replaced. The bronze nut or the trapezoidal thread should be
replaced as soon as abrasion is visible. It is essential that the bronze nut and the trapezoidal thread are kept clean.
12 Start up of cassettes
® Slice Holding Device, Manual closure
Previous Slice holder
and Slice 200 holder
Required
compression
14 – 17 kN
18 – 21 kN
14 – 17 kN
18 – 21 kN
Required Compression
Operating Conditions
18–35 kN
18–25 kN
20 and Sartoflow Systems with Hydraulic Piston, 12.5 cm
®
Required Compression
Operating Conditions
18–35 kN
18–25 kN
New Slice 200 and Slice
holder with trapezoidal
thread, PEEK washer and
bronze nut
(available since July 2014**)
Torque applied Torque applied with
with a torque a torque wrench
wrench
20 Nm 17 Nm
25 Nm 17 Nm
20 Nm 25 Nm
25 Nm 17 Nm
Torque applied
Sterilization* on Tie Rods with
a TorqueOperating
Conditions
< 10 kN 80 Nm
< 10 kN 60 Nm
Hydraulic Pressure
Sterilization* Operating Conditions Sterilization*
< 10 kN 170 bar (2466 PSI)
(17 MPa)
< 10 kN 170 bar (2466 PSI)
(17 MPa)
Sterilization*
Torque applied with
a torque wrench
Not applicable
Not applicable
Not applicable
Not applicable
Wrench
Sterilization*
first notch
first notch
2
80 bar (1160 PSI)
(8 MPa)
80 bar (1160 PSI)
(8 MPa)