Troubleshooting - nemaxx HW-2 Original-Gebrauchsanleitung

TROUBLE SHOOTING
DO NOT disconnect battery to quiet an unwanted alarm.
This will remove your protection. Fan the air or open a window to remove smoke or dust.
Problem
Smoke alarm device does not
sound when tested.
Smoke alarm beeps with the red
LED blinking about once every
40 seconds.
Smoke alarm sounds unwanted
alarms intermittently or when
residents are cooking, taking
showers, etc.
The alarm sounds different from
than usual.
It starts and stops.
EN
Method of disposal
Remove smoke alarm from bracket, then check the
battery is properly connect to battery connector.
Replace battery, please refer to "REPLACE BATTERY"
section.
1. Clean smoke alarm device.
Please refer to the "maintenance and cleaning"
section.
2. Hire an electrician to move smoke alarm to a new
location.
1. This alarm is operating correctly.
2. Clean smoke alarm device.
Please refer to the "maintenance and cleaning"
section.
9
Version: 2.0
30.03.2016