Installation - nemaxx HW-2 Original-Gebrauchsanleitung

INSTALLATION

• Fix the two AA batteries into each battery box of the smoke alarm.
• According to the "Wireless function description" section, set the smoke alarm.
Ensure the wireless function is working.
• Then hold the bracket on the installation position, mark installation holes of the bracket
with a pencil.
• Make two installation holes with an electric drill.
Make holes of 5mm diameter, place the two plastic plugs into hole.
• Attach the bracket into the plastic plugs and fix tightly with the screws (3*25mm)
(refer to Diagram 3).
• Fit the alarm on the bracket and turn the alarm body clockwise, until matching well on
the bracket.
• Test smoke alarm using test button. The alarm will sound 3 short beeps – 1.5 seconds
pause, then repeat it until you release the button.
• If there is no sound, it indicates a defective alarm, you can refer to "Trouble shooting" for
solution or contact your retailer during legal warranty.
• If you have any questions on installation, you can contact your retailer.
• During testing, the other smoke detectors will sound an alarm.
Once you release the button, the other detectors will stop alarming after approx. 1 minute.
This is how you can test the wireless function.
WARNING
To prevent injury, this unit must be securely attached to the ceiling in accordance
with the installation instructions.
EN
11
Version: 2.0
30.03.2016