Dometic MoBar300S Bedienungsanleitung Seite 20

Safety instructions
• Clean regularly surfaces that can come in contact with food and
accessible drainage systems.
A
NOTICE! Damage hazard
• Check that the voltage specification in this manual corresponds to that
of the energy supply. This data must correspond in order to avoid the
risk of damage to the device. Consult a qualified electrician if in any
doubt.
• Do not use a steam-cleaning device to clean the device. Steam could
reach the electrical components and cause a short circuit.
• Avoid locating the device in damp areas.
• Connect the cooling device with an AC connection cable to the AC
power supply.
• Never pull the plug out of the socket by the cable.
• Do not use accessories that have not been recommended by the
manufacturer. This can lead to injury and material damage.
• Do not lean on the device.
• Do not climb onto the device.
• Do not tilt the device, especially when it is fully loaded.
• Locate the device away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating
and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the device not to perform
properly.
• During periods of high humidity, some condensation may appear on
outside surface of glass door. This condensation will disappear when
humidity levels drop.
• Before first use clean the inside of the cooling device (see chapter
"Cleaning and maintenance" on page 28). Wait for 1 – 1.5 hours after
placing the appliance in its final position to allow the refrigerant to
settle before connecting it to the mains power supply.
20
MoBar300S/550S
EN