Intended Use; Safety Instructions - Konig & Meyer Biobased Aufstellanleitung

19743 Tablet PC holder »Biobased«

INTENDED USE

- Universal tablet holder fit for all tablets sized approx. 10" to 16".
- Particularly suited for Tablets with protective covers or casing up to 20 mm.
- With a support arm and clamp for side attachment for tripods, tubes, poles.
FEATURES & CAPABILITIES
- The holder is flexible and solid as well as being an absolute eyecatch.
- Equally suited for stage, home, rehearsal room and studio
- The clamping mechanism (including sideways Guard arm) enables a simple,
- effective and secure mounting of your Tablet PC
- Overlapping clamping jaws with integrated foam rubber coating ensure a secure hold,
- eliminate vibration noise and protect the Tablet case
- Generously dimensioned clamp for secure hold on tubes of ø 11-30 mm
- Adjustment options that leave nothing to be desired: Tablet size, tilt angle, direction,
- portrait/landscape: all individually adjustable
- Clamping range: height 158-280 mm, width 150-330 (430) mm,
- depth max. 20 mm
Thank you for choosing this product. Please read and follow the instructions carefully. They
inform you about all the important steps concerning assembly and handling. We recommend
you to keep them for future reference.

SAFETY INSTRUCTIONS

- Please use suitable stands - this implies: stability,
- load-bearing plus tube ø 11-30 mm.
- E.g. K&M stands 118/1, 199, 21020, 210/8 etc.
- As described attach the tablet carefully to the
- holder and check for security
- Handle the holder with care; especially when
- changing the settings (inclination, format and
- direction), ensure that the Tablet has a secure
- hold
INSTALLATION INSTRUCTIONS
PREPARE THE STAND (see above: Safety
Instructions)
1. COMPONENTS
Please visually check whether all parts are present
and in order - as far as recognizable.
a SWIVEL JOINT
a (with stand connection thread)
b TABLET CRADLE
b (base, slider, clamp)
c GUARD ARM
c (with felt and rubber cap)
d SUPPORT ARM with clamp
d (for max. tube-ø 30 mm)
e WING SCREW with rubber washer
2. CONNECTING SWIVEL JOINT with
2. SUPPORT ARM
2.1 Insert the WING SCREW e from below through
2.1 the borehole of the support arm and...
2.2 ...push the rubber washer e over the thread
2.2 as far as it will go
2.3 Screw the wing screw into the swivel joint
2.4 Hold the clamp of the SUPPORT ARM d
2.4 against the stand tube and fasten by
2.4 tightening the knurled screw.
3. PRESET the CRADLE
3.1 Loosen slightly the clamping nut...
3.2 ...and extend the slide as far as it will go
3.3 Retighten the clamping nut
4. ATTACHING the GUARD ARM
4.1 Insert GUARD ARM c into the correspon-
4.1 ding recess of the SWIVEL JOINT a.
NOTES:
4.2 Select the position of the arm so that the
4.2 tablet PC sits in the centre of the holder
4.2 and attaches sideways to the rubber of
4.2 the bracket (see also Chapter 8)
4.3 The Guard arm should be attached to the
4.3 swivel joint with at least 2 boreholes.
1. COMPONENTS
2. CONNECTING SWIVEL JOINT with SUPPORT ARM
3. PRESET the CRADLE 4. ATTACHING the GUARD ARM