Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
19743 Tablet PC holder »Biobased«
INSTALLATION INSTRUCTIONS
5. MOUNTING the TABLET CRADLE
5.
to the SWIVEL JOINT
5.1 PLACE THE TABLET CRADLE b on
5.1
the 4 hooks of the SWIVEL JOINT a
5.2 Then push the TABLET CRADLE b
5.2
down as far as it will go.
5.2
Pay attention to the clicking noise.
6. DISASSEMBLY of the TABLET CRADLE
e.g. to adjust the Guard arm c
6.1 Remove the tablet from the holder b, 7.10
6.2 Push the lever down and hold
6.3 Shift the TABLET CRADLE b upwards
6.3
as far as it will go until the connection
6.3
disengages with an distinguishable click.
6.4 Lift TABLET CRADLE b
6.5 Remove GUARD ARM c
6.6 If required, the SWIVEL JOINT a can be
6.6
unscrewed from the SUPPORT ARM d.
7. INSERT TABLET PC
7.1 Tilt cradle b backwards approx. 30°...
7.2 Tighten clamp of swivel joint a
7.3 Place Tablet on lower supports...
7.4 ...and lean on cradle b
7.4
NOTE:
7.4
The Tablet PC should rest:
7.4
a at the BACK,
7.4
b CENTERED and
7.4
c against the GUARD ARM C.
7.4 c
Depending on the size of the Tablet PC,
7.4 c
the position of the guard arm c should
7.4 c
be corrected
7.4 c
(see Chapter 6 and 4)
7.5 Loosen the clamping of the slider...
7.6 ...and retract the slider until the upper
7.6
attachment of the Tablet PC is securely
7.6
fastened to the cradle b. In this process,
7.6
the slightly compressed foam rubber
7.6
coating clamp the tablet.
7.7 Tighten the clamping again
7.8 Check firm seat of the tablet and
7.8
readjust, if necessary.
7.9 The foam rubber pads protect the
surface of the tablet and provide
7.9
7.9
additional clamping.
7.10 Remove the tablet in reverse order.
7.10
NOTE: Please hold the tablet securely,
7.10
especially when opening the clips.
8. TABLET PC POSITIONING
Generally suitable for TABLET PCs
from 10" to 16" screen size
(see Chapter 9).
8.1 Always position the TABLET PC in the
8.1
CRADLE in a centered and balanced
8.1
position
8.2 NOTE:
8.2
Off-center positioning may be neces-
8.2
sarydue to the size of the TABLET PC.
8.2
Please observe the balance of the
8.2
entire installation for safety reasons.
8.3 The Guard arm should always rest
8.3
against the TABLET PC and...
8.4 ...must be at the bottom - as additio-
8.4
nalsafety - if the TABLET PC is set
8.4
upright!
5. MOUNTING the TABLET CRADLE
6. DISASSEMBLY of the TABLET CRADLE
7. INSERT TABLET PC
8. TABLET PC POSITIONING
centered
Pivot
Tablet
point
center
off-center
Werbung
Inhaltsverzeichnis
