Konig & Meyer Biobased Aufstellanleitung Seite 7

19743 Tablet PC holder »Biobased«
INSTALLATION INSTRUCTIONS
9. TABLET PC DIMENSIONS
The clamping range includes:
9.1 - in depth up to 20 mm
9.2 - in width from 150 - 430 mm
9.3 - in height from 158 - 280 mm
9.4 - in diagonal approx. 10" - 16"
ADJUSTMENTS
When adjusting
10. TILT
11. FORMAT
12. DIRECTION
the TABLET PC can remain in the holder.
10. TILT
The TABLET PC can be fixed in any position
between vertical and horizontal end position.
10.1 Hold Tablet and loosen wing nut,
10.2 tilt Tablet as desired and
10.3 retighten wing nut.
11. FORMAT
The Tablet PC holder has a 90° swivel
function.
11.1 Hold the tablet and turn it to lands-
11.1 cape or portrait mode - or position
11.1 at an angle!
11.1 Invisible stops in the swivel joint
11.1 limit the rotation
11.2 NOTE:
11.2 Install guard arm c so that the stop
11.2 is at the bottom when the tablet is
11.2 aligned vertically; if necessary, the
11.2 guard arm must be inserted into the
11.2 swivel joint rotated by 180°
11.2 (see Chapter 4)
12. DIRECTION
12.A 360° ROTATION of the Tablet
12.A AROUND ITS OWN AXIS
12.A.1 Loosen wing screw,
12.A.2 turn cradle in desired
12.A.2 direction,
12.A.3 re-tighten wing screw.
12.B 360° ROTATION of the support
12.B arm AROUND THE STAND
12.B.1 Hold support arm,
12.B.2 loosen knurled screw,
12.B.3 turn support arm in desired
12.B.3 direction,
12.B.4 re-tighten knurled screw.
9. TABLET PC DIMENSIONS
10. TILT
11. FORMAT
Landscape
12. DIRECTION
Portrait