Inhaltsverzeichnis
Werbung
Safety, performance, and dependability have been given
top priority in the design of your buffer/polisher.
INTENDED USE
The product is intended for polishing and buffi ng cars,
boats, recreational vehicles, watercrafts, motorcycles,
hardwood fl oors, and large furniture.
Do not use the product in any way other than those stated
for intended use.
WARNING
Read all safety warnings and all instructions. Failure
to follow the warnings and instructions may result in
electric shock, fi re and/or serious injury.
Save all warnings and instructions for future reference.
MAINTENANCE
■
When servicing, use only original manufacturer's
replacement parts. Use of any other parts may create a
hazard or cause product damage.
■
Do not use compressed air to blow dust/dirt from any
power tool. Serious eye injury could result. Use a cloth,
brush or vacuum to remove dust and dirt.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
■
Do not attempt to modify this tool or create accessories
not recommended for use with this tool.
■
For greater safety and reliability, all repairs should be
performed by an Authorised Ryobi Service Centre.
APPLICATION AND BUFFING/POLISHING BONNETS
■
Both the application and buffing/polishing bonnets are
reusable. For maximum life and performance, hand
wash after use and allow them to air dry. If needed, the
bonnets can be machine washed in cold water with a
small amount of detergent, then machine dried using
low heat.
FOAM PAD
■
It is important that the pad retain its original shape and
dimensions. Allow it to dry completely after each use.
Make sure to remove the bonnets, wash them, and
store separately. The product should be stored with the
pad facing up in order to extend pad life and retain its
shape. Be careful not to use too much polish at one
time. If the pad becomes saturated, it will not last as
long.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
Safety alert
No-load speed
iameter
D
CE conformity
EurAsian Conformity Mark
Please read the instructions carefully
before starting the machine.
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or retailer
for recycling advice.
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR
1
Werbung
Inhaltsverzeichnis
