Klarstein MANHATTAN Handbuch Seite 15

OPERATION
Control panel
ON/OFF
LED „ADD WATER"
LED „ICE FULL"
Before use
• Allow the unit to stand on a flat surface for 2 hours after unpacking and
before first use.
• The device is not intended for use with distilled water.
• Do not use the device with water that has stood for more than 24 hours.
Operation
1. Open the lid. Fill the water tank with water. The water level should not exceed
the ice tank,
2. Make the power connection.
3. Press the on/off switch. The unit starts to operate.
4. If the „add water" led lights up, add water. If no water is pumped, briefly
remove the silicone plug.
5. If the „ice full" led lights up, remove the ice. 6.
6. Turn off and unplug the unit after use.
Notes: During the first three cycles of operation, the ice cubes will be
comparatively small and uneven.
Press it to turn unit on or off.
This light will come on with a long noise, DI' noise. You
will need to add water and press the ,STOP' then the
,START' button to restart the ice maker.
This light will come on with a ,DI, DI' noise when the
ice has reached the maximum capacity of the storage
cabinet. Press ON/OFF button to restart the Iee maker
after some of the ice has been taken away.
EN
15