DeWalt DWD115K Bedienungsanleitung Seite 27

mainTenance
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-ups
or when making repairs. Be sure the
trigger switch is in the OFF position. An
accidental start-up can cause injury.
motor brushes
D WALT uses an advanced brush system which
e
automatically stops the drill when the brushes wear
out. This prevents serious damage to the motor.
New brush assemblies are available at authorized
D WALT service centers. Always use identical
e
replacement parts.
lubrication
Your power tool requires no additional lubrication.
cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
Optional accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
e
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
CAUTION: To reduce the risk of injury,
the following accessories should be
used only in sizes up to the maximums
shown in the table below.
maXimUm recOmmenDeD caPaciTies
Drill capacity
R.P.M.
Bits, metal drilling
Wood, flat boring
Bits, masonry drilling
Hole saws
ACCESSORY MUST BE RATED FOR USE AT
SPEED EQUAL TO OR HIGHER THAN NAMEPLATE
R.P.M. OF TOOL WITH WHICH IT IS BEING USED.
Wire wheel brushes
Wire cup brushes
Buffing wheels
Rubber backing pads
Protecting the environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
e ngl ish
WALT, have
e
3/8" (10 mm)
0-2,500
3/8" (10 mm)
1" (25.4 mm)
1/2" (12.7 mm)
1-1/8" (28.4 mm)
4" (101.6 mm)
diameter maximum
3" (76.2 mm)
diameter maximum
3" (76.2 mm)
diameter maximum
4-5/8" (117.4 mm)
diameter maximum
WALT product
e
25