Care And Cleaning; Troubleshooting - Klarstein AUDREY RETRO Bedienungsanleitung

EN
22

CARE AND CLEANING

The refrigerator should be cleaned once a month. Before cleaning, the electric plug must
be removed from the power supply. Wipe the inside and the outside of the refrigerator
with a wet soft cloth. If it's too dirty, clean with a soft cloth with neutral detergent and,
then remove the moisture with dry cloth.
If you leave the refrigerator idle for a long time
• Disconnect the refrigerator from the electric power supply.
• Remove all food.
• Clean and dry the inside as instructed in the direction given above for cleaning.
• Leave the doors open to prevent any unpleasant smells while the refrigerator is not
used.
Replacing the light bulb
If the internal light does not work anymore, disconnect then reconnect at once the
device. If the light does not still work, verify if the light bulb is correctly screwed. If in
spite of these tests, there is no light, it is necessary to change the light bulb. Use a 1W
LED light bulb.
• Disconnect the appliance;
• Open the light cover (1);
• Undo the defective light bulb anticlockwise.
• Screw the new light bulb clockwise.

TROUBLESHOOTING

The following symptoms are not breakdowns:
• The noise of the cooling liquid which circulates in pipes can be heard, it is normal.
• The humidity on the surface outside of the device during the wet seasons is not a
problem of the device; you just need to wipe it with a dry soft cloth.
• The compressor and the condenser can warm more during the periods of strong
heat.
• The frame of the door is a bit hot; it means that the condenser works to evacuate the
humidity of air.