Werbung
7) Remote functions
Button for the next song
Start / Pause
Timer
Reduce speed
Increase speed
Use
1. Rocking function:
Five rocking speeds are available. Pressing the "+" button can increase the speed. The indicator will light up when you
press the "+" button, which means that the swing has started. Following the indicator lights will light up one after the
other, while the swing speeds will be higher and higher. The rocking speed will be slower and slower until the rocking
stops and all the lamps are turned off.
2. Swing timer:
The swing has three swing timers. Press the button, one indicator light lights up for 20 minutes, press the second time
when two lights light up for 40 minutes, press the third time, three lights light up for 60 minutes, all functions will stop
after the set time reaches . If you do not start the time setting function, all other running functions will continue to
operate until the power is turned off.
3. Music toggle button:
Press once to start, press a second time to stop the music.
4. Button for next song:
Each time you press the button, you move on to the next song.
5. Last song button:
Each time you press the button, the last song is played.
6.Button for swinging:
Press the button, the indicator will light up. (Automatic start to the lowest rocking mode of the product)
7. Battery:
This product can be used with 4 * 1.5V AA batteries or adapter.
Inserting the batteries:
As shown, loosen the screw with a screwdriver, then remove the cover and insert the batteries according to the correct
polarity in the battery compartment. Remove the batteries in the same way.
8.Movement without remote control:
To move the swing freely, pull
the button up.
13
Button for the last song
Volume down button
Mute button
Move button
Batteries
To rotate 20 degrees,
push the button
down.
1. Cadrul principal de sustinere.
① Tineti apasat butonul, introduceti tubul de sustinere dreapta in tubul de sustinere stanga. (C).
② Tineti butonul la tuburile de sustinere stanga si dreapta cu ambele maini, apoi introduceti-le in
cadrul principal de sustinere in acelasi timp. (A si B)
2. Aliniati cele doua parti ale tuburilor pe cadrul scaunului cu cele doua tuburi de fier din grupul de reglare a
scaunului, apasati pana la limita, asa cum este aratat in imaginile de mai jos.
3. Montarea husei scaunului:
Introduceti husa scaunului in cadrul scaunului, exact pana in partea de jos si fixati pe ambele parti, asa cum este
aratat in imaginile de mai jos.
45
Werbung
