Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions
Installation and commissioning
i
Install the safety storage cabinet so that the annual maintenance activities can
be carried out without restriction.
6.1 Requirements for the installation location
The safety storage cabinet is approved for installation in a building.
Fig. 28: Requirements for the installation location
Consider the following in relation to the installation location:
▪
The surface must be able to bear the weight of the safety storage cabinet when fully
loaded.
▪
The surface must be horizontal to guarantee problem-free functioning of the safety
storage cabinet.
▪
The load-bearing capacity and stability of the surface must be assured both in normal
situations and in the event of a fire.
▪
Do not install the safety storage cabinet near sources of heat.
▪
Protect the safety storage cabinet against moisture.
–
At a relative humidity of >70 % use in closed and heated buildings is permissible
for a few weeks each year.
▪
The operating temperature must be between -5°C and +40°C.
6.2 Aligning the safety storage cabinet
i
The alignment procedure described below is used for precision alignment.
Remedy any major floor unevenness of more than 15 mm on site.
The safety storage cabinet is supplied without alignment elements. An alignment may be
necessary in individual cases.
Personnel:
▪
Technically qualified personnel
Special tool:
▪
Suitable tool
➔
Raise the safety storage cabinet slightly.
➔
Place steel or stainless-steel spacers underneath the safety storage cabinet.
➔
Check the alignment.
Chapter 6.4 "Ausrichtung des Sicherheitsschrankes kontrollieren" on page 67
➔
Set the safety storage cabinet down carefully.
DISPOSAL UTS ergo, DISPOSAL BENCH
65
Werbung
Inhaltsverzeichnis
