Technical Data; Installation - AEG SCS81800F0 Benutzerinformation

80

Technical data

Problem
The temperature in the
freezer is too high.
There is too much frost.
Replacing the lamp
The appliance is equipped with a longlife LED interior light.
Only service is allowed to replace the lighting device. Contact your Service Center
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

Positioning
WARNING!
If you are discarding an old appliance that has a lock or catch on the door, you must
ensure that it is made unusable to prevent young children being trapped inside.
The appliance shall have the plug accessible after installation.
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Possible cause
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is
not set correctly.
Height
Width
Depth
Solution
Store products so that there is
cold air circulation.
Wrap the food correctly.
Set a higher temperature.
1780 mm
560 mm
550 mm
24 h