Klarstein Polar Tower Smart Handbuch Seite 21

2. ON/OFF: Turn the FAN on by pressing the 'ON/OFF' button, turn the FAN off by
pressing the 'ON/OFF' button again.
3. When switched on, the unit will first operate in second wind speed, normal mode.
4. SPEED: You can adjust the fan speed to the desired level, by pressing 'SPEED'
button, total 4 speeds.
5. MODE: Pressing the MODE button will set the FAN into NORMAL, NATURAL or
SLEEP mode. The corresponding icon will be lighted up on the display.
6. TIMER: Press this button to set the running time of the fan, the corresponding icon
will be lighted up on display. The fan can be adjusted from 1 hour to 24 hours.
Pressing the button once will set the timer at 1 hour, press the button twice and the
timer will set at 2 hours and so on until a maximum of 24 hours can be set.
7. SWING: Press this button once to start the swing function, the corresponding icon
will be lighted up on display. Press a second time to stop the swing function.
8. COOL: Touch "COOL", cool function start work and the corresponding icon will
be lighted up.
a. Before operating the unit in Cool mode, make sure the water pump in the water
tank is properly fixed, then add clean water into the water tank. While adding
the water, make sure that you keep an eye on the water level indicator to make
sure that you do not over or under fill the unit. Press the button Cool after you
have added the water and the unit should commence to blow cooler air. The
cool icon will light on at the same time. When you press the button Cool again,
it will stop working, the cool light will also go out.
b. If you find that the air after Step 1 is still not cool enough, you can add
additional ice blocks into the water tank directly. Be sure not to exceed the
water tank capacity otherwise damage to the unit or electric shock may occur.
c. If you wish to use an Ice box instead of ice block, just place it directly into the
water tank. It will be good cooling efficiency if you place it in freezer and let
the ice boxes freeze for 1 to 2 hours.
d. You may completely pull out water tank, then replace water in the water tank
or clean water tank.
e. Under the cooling work condition or you ever used cooling function, the
appliance will keep on blowing 3 minutes if you shut off the unit or timing
finished.
9. Ionizer: When the Ionizer button is pressed, the Ionizer function is enabled to
work and purify the passing air.
10. How to knock down the honeycomb filter: Pull out the rear bracket from the top
of the bracket, and then take up the honeycomb filter.
NORMAL NATURAL SLEEP