Loading Media - AstroNova QuickLabel QL-850 Kurzanleitung

16. Open the top cover and verify that ink has filled all of the five tubes shown below.
If ink is not visible in all of the indicated tubes, contact Technical Support. Do not run
the After Shipping Wizard in the QL-850 Maintenance Utility again or an ink overflow
may occur.
17. Close the top cover.

Loading Media

1. Turn the wing nut [1] on the end of the mandrel counterclockwise to loosen the mandrel.
2. Loosen the fastener on the outer flange [4]. Then remove the outer flange from the
mandrel.
3. Orient the media roll [2] as illustrated and put it on the mandrel. Make sure the roll makes
contact with the inner flange [3].
4. Turn the wing nut [1] on the end of the mandrel clockwise until you feel resistance. This
secures the roll in place.
5. Put the outer flange [4] on the mandrel. Make sure the outer flange makes contact with the
roll [2].
6. Tighten the fastener on the outer flange [4] until you feel resistance. This secures the outer
flange in place.
7. On the front of the printer, slide the media exit guide [5] all the way to the right toward the
control panel. You can adjust this guide before printing.
8. Place the media near the entry slot.
10 QL-850 Quick Start Guide