Tie The Cuff - Salter BPA-9301-EU Bedienungsanleitung

MEASUREMENT

Tie the Cuff

1. Tie the cuff on your
upper arm, then position the
tube off-center toward the
inner side of arm in line with
the little finger. Or position the
artery mark over the main
artery (on the inside of your arm).
Note: Locate the main artery by pressing
with 2 fingers approximately 2 cm above the
bend of your elbow on the inside of your left arm.
Identify where the pulse can be felt the strongest.
This is your main artery.
2. The cuff should be snug but not too tight. You
should be able to insert one finger between the cuff
and your arm.
3. Sit comfortably with your tested arm resting on a
flat surface
4. Patients with Hypertension:
The middle of the cuff should be at the level
of the right atrium of the heart; Before starting
measurement, please sit comfortably with legs
uncrossed, feet flat on the floor, back and arm
supported.
• Rest for 5 minutes before measuring.
• Wait at least 3 minutes between measurements.
This allows your blood circulation to recover.
• For a meaningful comparison, try to measure
under similar conditions. For example, take
daily measurements at approximately the same
time, position of upper arm, or as directed by a
physician.
Start the Measurement
1. When the monitor is off, press "
the monitor, and it will finish the whole measurement.
(Take user 1 for example.)
LCD display
Inflating and measuring.
2. This device will proceed to data transmission after
measurement. The Bluetooth symbol blinks on the LCD
indicates data is transmitting.
Transmitting
3. With BPA-9301-EU successfully pair-up with
your mobile device, the measurement data will be
automatically transmitted to your mobile device via
Bluetooth.
(1). The symbol will disappear after successful data
transmission, and you may check your personal health
data stored in your mobile device.
(2). If the data transmission fails, the symbol will remain
The pending measurement data will be transmitted
to your mobile device when next measurement is
complete.
4. Press the " " button to power off, otherwise it will
turn off within 1 minute.
9 I UK
" button to turn on
Adjust the zero.
Display and save the measurement
results. The year, date and time
will display alternately.
Complete