Troubleshooting - Siemens slider SL20 Gebrauchsanleitung

G
Storing the appliance
1. Always allow the appliance to cool down before
storing it.
2. Set the main power to the "0" position and
disconnect the mains cable.
3. Empty the water tank.
4. Place the iron on the iron pad, standing on the
soleplate.
5. Store the mains cable in the storage
compartment (5) and the steam hose in the
storage fixing (3). Do not wrap the cords too tight.
6. Use the carrying handles (4) on the sides when
moving the appliance.
Tips to help you save
energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
• Start by ironing the fabrics that require the
lowest ironing temperature.
Check the recommended ironing temperature
in the label on the garment.
• Regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
• Only use steam if necessary. If possible, use
the spray function instead.
Trouble shooting
Problem Possible causes
The steam • There is a connection problem.
generator does not
come on. • The main power button is not
switched on.
The iron does not • The main power button is not
heat up. switched on.
• The temperature control knob is
set to the "min" position.
The iron begins to • During first use: Certain
smoke when components on the appliance
switched on. have been lightly greased at the
factory and may produce a little
smoke when initially heated.
• During later use: the soleplate may
be soiled.
• Try to Iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the iron.
If you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
programme.
• If the fabrics are damp enough, turn off the
steam regulator completely.
• Stand the iron upright during pauses. Resting it
horizontally with the steam regulator on
generates wasted steam.
Disposal
Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the
local waste disposal service as secondary raw
materials. Your local town council can give you
information about how to dispose of obsolete
appliances.
This appliance is labelled in
accordance with European Directive
2012/19/EU –concerning used
electrical and electronic appliances
(waste electrical and electronic
equipment WEEE).
The guideline determines the framework for
the return and recycling of used appliances
as applicable throughout the EU.
Solution
• Check the mains cable, the plug and
the socket.
• Set the main power button (13) to the
"I" position.
• Set the main power button (13) to the
"I" position.
• Set the temperature control knob (15)
to the desired position.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
19
SI EME NS